Beginner's Guide to Amydor Die Cutting Machines

Beginners can quickly get started with Amydor die cutting machines by mastering three key points: "model selection - operation - avoiding mistakes":

1. Model Selection: Suitable Models for Beginners  
Prioritize choosing Amydor desktop die cutting machines：  
Desktop Machines: Covering an area of ≤0.5㎡, with 8+ preset modes (paper crafts, stickers, etc.), no complicated settings, suitable for handcraft creation.  
2. Basic Operation: Complete in Four Steps  
Step 1: Load materials,lay flat and align with Amydor's automatic guide to avoid wrinkles.  
Step 2: Select the mode (click the corresponding scenario on the touchscreen, such as "Notebook Decoration", and the system automatically matches the speed and pressure).  
Step 3: Install the mold (the sharp side faces down, fix it firmly; beginners are recommended to use Amydor's preset molds).  
Step 4: Click "Start", wait for the cutting to complete, and use tweezers to take off the finished products.  
3. Avoiding Mistakes for Beginners: Key Notes  
Material Thickness: Do not exceed 5mm (the upper limit of Amydor models), as excessive thickness will damage the mold.  
Pressure Adjustment: Beginners should first use the preset parameters and not blindly increase the pressure (excessive pressure on thin materials may cut through them).  
Mold Maintenance: Clean residues after each use and store in a dry place to avoid rust.  
4. Common Problems: Solutions for Beginners  
Cutting Deviation: Realign the materials. Amydor's automatic guide has scales for easy alignment.  
Finished Products Sticking to Molds: Gently sweep the mold with a brush, or spray a small amount of release agent.  
Machine Alarm: Check if the materials are jammed, turn off the power and restart; if the problem persists, contact Amydor's after-sales service.  
Amydor is a die cutting machine manufacturer from Zhengzhou, China. Beginners can get free operation videos. Feel free to leave a message!